cat

Type:command
Package:prepDATA/1.1 — Conversion, Transformation and Plotting of Basic Data Files
Namespace:&type2

Description

The cat utility reads files sequentially, writing them to the standard output.

Usage

cat
Bash equivalent: cat -v
manpages
File: manpages, Node: cat, Up: (dir)
.
.
CAT(1) BSD General Commands Manual CAT(1)
.
NAME
cat – concatenate and print files
.
SYNOPSIS
cat [-benstuv] [file …]
.
DESCRIPTION
The cat utility reads files sequentially, writing them to the standard
output. The file operands are processed in command-line order. If file
is a single dash (`-‘) or absent, cat reads from the standard input. If
file is a UNIX domain socket, cat connects to it and then reads it until
EOF. This complements the UNIX domain binding capability available in
inetd(8).
.
The options are as follows:
.
-b Number the non-blank output lines, starting at 1.
.
-e Display non-printing characters (see the -v option), and display
a dollar sign (`$’) at the end of each line.
.
-n Number the output lines, starting at 1.
.
-s Squeeze multiple adjacent empty lines, causing the output to be
single spaced.
.
-t Display non-printing characters (see the -v option), and display
tab characters as `^I’.
.
-u Disable output buffering.
.
-v Display non-printing characters so they are visible. Control
characters print as `^X’ for control-X; the delete character
(octal 0177) prints as `^?’. Non-ASCII characters (with the high
bit set) are printed as `M-‘ (for meta) followed by the character
for the low 7 bits.
.
EXIT STATUS
The cat utility exits 0 on success, and >0 if an error occurs.
.
EXAMPLES
The command:
.
cat file1
.
will print the contents of file1 to the standard output.
.
The command:
.
cat file1 file2 > file3
.
will sequentially print the contents of file1 and file2 to the file
file3, truncating file3 if it already exists. See the manual page for
your shell (i.e., sh(1)) for more information on redirection.
.
The command:
.
cat file1 - file2 - file3
.
will print the contents of file1, print data it receives from the stan-
dard input until it receives an EOF (`^D’) character, print the contents
of file2, read and output contents of the standard input again, then
finally output the contents of file3. Note that if the standard input
referred to a file, the second dash on the command-line would have no
effect, since the entire contents of the file would have already been
read and printed by cat when it encountered the first `-‘ operand.
.